Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Rear Window
❑ Distance -a- to upper lid
edge = 2 mm
❑ Even out distance -b- to
side lid edge = 2.5 mm.
❑ Before removing, dis‐
connect all electrical
connectors and secure
to inside center of win‐
dow with adhesive tape.
❑ When installing, center
window all around in
window opening.
2 - Adhesive sealing material
❑ Apply all around be‐
tween adhesive stopper
profiles
• Bead width = 8 mm
+/- 2 mm
• Bead height = 12 mm
+2 mm
3 - Connector
❑ Disconnect when re‐
moving window.
❑ Clipped into lid flange.
4 - Adhesive stopper profile
❑ Apply window adhesive
between profiles.
Undamaged Rear Window, Removing
– Remove rear lid trim. Refer to ⇒ Body Interior; Rep. Gr. 70 ;
Removal and Installation .
– Disconnect rear window defroster and window antenna con‐
nectors and secure to center of window with adhesive tape.
1.2
Bolted Windows
⇒ “1.2.1 Door Window, Adjusting“, page 193
1.2.1
Door Window, Adjusting
Special tools and workshop equipment required
♦ Template -T40038/7-
♦ Side window installation tool -V.A.G 1739- and screwdriver
Torx T25 -T10248-
Height Adjustment
Note
Door trim must not be removed for height adjustment.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1. Description and Operation
193
