Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
With New Window
– Clean window all around in adhesive area using Cleaning Sol‐
ution -D 009 401 04- .
– Apply Glass and Paint Primer -D 009 200 02- all around in
adhesive area.
• Drying time 10 minutes.
Side Window, Installing
– After the preparatory work has been performed, cut nozzle tip
as shown in illustration.
• Dimension -a- 12 mm
Note
Cross-section thickness of adhesive bead is determined by di‐
mension of opening in nozzle tip and rate of application.
Dimensions for adhesive application:
1 - Adhesive sealing material
2 - Primer
3 - Window
• Dimension -a- = 8 mm
+2 mm
• Dimension -b- = 12 mm
+3 mm
• Distance -c- = to window edge is given through the window
molding.
– Position complete surface of nozzle -2- onto window.
• Application direction -arrow- for adhesive bead -1-.
– Apply adhesive sealing material all around near window mold‐
ing.
– With an undamaged removed window, apply adhesive to re‐
maining bead.
Note
Use 1K Window Adhesive -DH 009 100 03- (small cartridge), or
2K Window Adhesive Kit -DA 004 600 A2- can also be used if
more than one window must be bonded.
– Press in window with securing pin at C-pillar, then insert in
window opening and secure with pop rivets in B-pillar area.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
206
Rep. Gr.64 - Glass, Window Regulators
