Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.1.2
Front Bumper
Special tools and workshop equipment required
♦ Hose Clamps up to 25 mm diameter. -3094-
♦ Socket -T40078-
1 - Bumper
Note
❑ Removing
– Unclip covers -2- and
-9-
– Remove bolts
-3-;-4-;-5- and -6-.
– Loosen wheel housing
liner in nut area -10- and
– Remove zero gap con‐
nection nuts -10-.
– Remove the lower
screws from the noise
insulation in the bumper
area.
– Unclip bumper side‐
ways from guide pieces
and pull forward slightly.
– Remove electrical wire
to fog lamp, clamp off
line to headlamp washer
system if necessary.
– Bumper completely
from vehicle
❑ Installing:
– Use markings on radia‐
tor grille -arrow- for ex‐
act adjustment length‐
wise.
– When installing, tighten upper bolts on bumper in -3-;-4-;-5- and -6- sequence.
2 - Right cover
❑ Unclip
3 - Bolt
❑ 5 Nm
4 - Bolt
❑ 5 Nm
5 - Bolt
❑ 5 Nm
6 - Bolt
❑ 5 Nm
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
165
