Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.4.3
Radiator Grille
Removing
– Remove the license plate bracket. Refer to
⇒ “3.4.1 License Plate Bracket“, page 236
– Remove bumper. Refer to
⇒ “2.4.1 Rear Bumper“, page 182
– Remove the bolt -2-.
– Unlock retaining clip -1- along the screws and press the radi‐
ator grille partly out of the bumper.
– Carefully press securing tab -3- up and release retaining tab
-4- while detaching the radiator grille from mount -5- -arrow-.
– Remove radiator grille -6- from the bumper.
Installation
• For the correct tightening specifications, refer to
⇒ “1.2.1 License Plate Bracket Assembly Overview“,
.
Install in reverse order of removal. Note the following:
– Press on the radiator grille until it engages completely
– Install the bumper. Refer to
⇒ “2.4.1 Rear Bumper“, page 182
.
– Install the license plate bracket. Refer to
⇒ “3.4.1 License Plate Bracket“, page 236
3.5
Spoiler - TT
⇒ “3.5.1 Rear Lid Spoiler“, page 237
⇒ “3.5.2 Front Wheel Spoiler“, page 239
⇒ “3.5.3 Rear Wheel Spoiler“, page 240
3.5.1
Rear Lid Spoiler
Caution
♦ The adjusting elements and screws for securing the spoil‐
er must always be replaced when replacing the spoiler.
♦ The water drain hoses must be replaced when removing
and installing the drive unit.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
3. Removal and Installation
237
