Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.2.4
Left and Right Striker Pins
Removing
– Open the hood.
– Remove the bolt -1- and the striker pin anti-twist mechanism
-2-.
– Remove lid lock striker pin -3-.
Installation
• For the correct tightening specifications, refer to
⇒ “1.2.1 Hood Assembly Overview“, page 12
Install in reverse order of removal. Note the following:
– Striker Pin, Adjusting, refer to
⇒ “1.2.3 Hood, Adjusting“, page 14
2.2.5
Impact Guard
Special tools and workshop equipment required
♦ Hot air gun -V.A.G 1416-
♦ Cleaning solution -D 009 401 04-
Removing
– Open the hood.
– Carefully warm impact guard -1- with the -V.A.G 1416- and
remove from hood -2- in the area of the adhesive surface.
– Remove the impact guard.
Installation
Install in reverse order of removal. Note the following:
– Use -VAS 6349- to remove any remaining adhesive.
– Clean the adhesive surfaces with cleaning solution -D 009 401
04- .
– Remove the protective film and insert guide -2- on impact
guard -1- into the mount of hood -3-.
• The impact guard must be flush with the outer edge of the
hood.
– Press on the entire length of the impact guard.
2.2.6
Gas-Filled Strut
Note
Different gas-filled struts are installed and their removal varies.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
40
Rep. Gr.55 - Hood, Lids
