Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.8.2
Selector Lever Boot, Separating from
Selector Lever Handle, Vehicles
through MY 2012
Removing
– Remove the selector lever handle. Refer to
⇒ “1.8 Selector Lever Handle, Removing and Installing”, page
– Bind the selector lever handle spring tabs -A- together with
cable ties -B-, as shown in the illustration.
– Slide the selector lever boot sleeve -C- over the tabs on the
spring tab in direction of -arrow-.
– Remove the cable ties and the selector lever boot and sleeve
from the selector lever.
Installing
Install in reverse order of removal. Note the following:
Selector lever boot installed position
• The longer side of the selector lever boot frame faces the driv‐
er side.
– Install the selector lever handle. Refer to
⇒ “1.8 Selector Lever Handle, Removing and Installing”, page
1.8.3
Selector Lever Handle with Side Lock‐
ing Button, Removing and Installing, Ve‐
hicles from MY 2013
Special tools and workshop equipment required
♦ Trim Removal Wedge - 3409-
♦ Thin cable ties or the assembly aid for the button on the han‐
dle. The assembly aid is already installed at the factory when
a new handle is ordered.
Removing
– Press the button on the electro-mechanical parking brake to
activate it.
– Move the selector lever into “N”.
Note
Both the selector lever handle and the selector lever boot are re‐
moved.
Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
36
Rep. Gr.37 - Controls, Housing
