ATX DigiVu II, Operation Manual, Page: 47 / 114

CHAPTER 1: TRANSCODING APPLICATION
VersAtive
®
Pro, DigiVu
®
II, DigiVu
®
II Micro – Operation Manual 5-1
TRANSCODING APPLICATION
5. Transcoding Application
This chapter describes how to set up an IP stream from an Ethernet port for Transcoding an SPTS stream.
5.1 Chapter Contents
• “Ethernet Resources”
• “SPTS Transcoding”
• “Adaptive Transcoding”
• “Start the Stream”
5.2 Ethernet Resources
An Ethernet Resource is an input to the platform which exists on one of the Ethernet interfaces as an IP stream. These
resources are used as source content for subsequent transcoding.
5.2.1 Create an Ethernet Resource
1. Click on the Device icon, Figure 1-1.
2. Click
Add Resource
on the tool bar (or Right Click menu).
3. In the window that opens, select Ethernet from the Type drop down choices, Figure 1-2,
4. Choose the physical rear panel Ethernet port that the stream appears on from the
Card
choices, eth1, eth2, eth3 or
eth4. (Depending on the model ordered, there may be more or less Ethernet port choices).
5. Enter the
IP address
,
Port
and
Protocol
of the IP stream to be ingested, Figure 1-3.
6. Tick the Multicast box if this is a multicast stream with an address in the multicast range.
7. If the Stream is a Source Specific Multicast (SSM), enter the Source IP Address.
8. Click
Analyze .
Figure 1-1: Add New IP Resource to Device
Figure 1-2: Select Input and Output Ports Figure 1-3: Enter Input IP Address and Port