ATLET A-Ergo, Service Manual

Page: 115 / 250

ATLET SERVICE MANUAL A-ERGO ATLET SERVICE MANUAL A-ERGO
M Mas ast t s sys yste tem m / / Re Repa paiir r in inst strru uct ctiio on ns / s / Si Sid de e st sta ab bil iliise sers rs 6 6.3 .37 7
Side Side stabilise stabilisers rs
Checking the side stabiliser Checking the side stabiliser
1. 1. Pl Plac ace t e the he tr truc uck o k on a n a le leve vel s l surf urfac ace. e.
2. 2. Fix a Fix a tape m tape measur easure with e with the ze the zero at th ro at the top e top edge edge of on of one fork e fork. Lift u . Lift until th ntil the stab e stabilise iliserr
switch in the mast breaks, i.e. until the switch in the mast breaks, i.e. until the mast stops, and measure the height. Lift mast stops, and measure the height. Lift
height should be at 3000 mm +/- 25 mm. height should be at 3000 mm +/- 25 mm.
3. 3. Exten Extend the d the stabi stabilisers lisers until th until the mo e motor st tor stops. C ops. Check heck that that the wh the wheels eels are pr are pressed essed
against the floor against the floor and check the residual suspension. See table 6.6. and check the residual suspension. See table 6.6.
Adjusting the length of side stabilisers Adjusting the length of side stabilisers
•• Mec Mechan hanica ical ad l adjust justmen ment is m t is made ade by a by adju djusti sting th ng the lo e lower e wer end o nd of the f the pis piston ton..
Table 6.6 Table 6.6 Reference values for side stabilisers Reference values for side stabilisers
Reference values for side stabilisers Reference values for side stabilisers
When the stabilisers are extended at full speed the spring should compress When the stabilisers are extended at full speed the spring should compress
4-9 mm, when the pump motor has stopped. Irregularities in the floor are
4-9 mm, when the pump motor has stopped. Irregularities in the floor are
absorbed by the spring in the top of the cylinder, see figure
absorbed by the spring in the top of the cylinder, see figure 6.38 6.38 below. below.
Residual suspension with fully extended stabilisers and a Residual suspension with fully extended stabilisers and a
level f level floor loor..
5-10 mm 5-10 mm
Figure 6.38 Figure 6.38 Check points for side stabilisers Check points for side stabilisers
06_003_A-Ergo_SidoStab.eps 06_003_A-Ergo_SidoStab.eps
https://www.besttruckmanuals.com/