ATLET A-Ergo, Service Manual

Page: 160 / 250

SERVICE MANUAL A-ERGO SERVICE MANUAL A-ERGO
8. 8.34 34 Hy Hydr drau auli lic c sy syst stem em / / Re Repa pair ir iins nstr truc ucttio ions ns / S / Sta tabi bili lise ser r cy cyli lind nder ers s
Stabiliser cylinders Stabiliser cylinders
The stabiliser cylinders have in their The stabiliser cylinders have in their upper end a flexible attachment, the upper end a flexible attachment, the purpose of purpose of
which is to compensate for minor irregularities in the floor which is to compensate for minor irregularities in the floor
Dismantling and assembling the stabiliser cylinders Dismantling and assembling the stabiliser cylinders
1. 1. Run Run out out th the st e stabi abilise liser c r cyli ylinde nders rs com comple pletel tely y..
2. 2. Remov Remove the e the cotte cotter in th r in the upp e upper atta er attachme chment. Fi nt. First gri rst grip the p the cylin cylinder wit der with one h one hand hand,,
and then pull out the and then pull out the HCB bolt. This is because of the pretension in HCB bolt. This is because of the pretension in the spring unit. the spring unit.
3. 3. Lift t Lift the he stabil stabilisers isers sligh slightly tly to re to release lease the the prete pretension nsion in th in the sp e spring ring unit. unit.
4. 4. Pu Pull ll ou out t t the he ba batt tter ery p y plu lug. g.
5. 5. Re Rele leas ase t e the he ho hose ses a s and nd pl plug ug th them em..
6. 6. Rem Remove ove the l the lowe ower scre r screw th w that go at goes th es throu rough th gh the pi e pisto ston rod n rod end end..
Dismantling and assembling, gaskets Dismantling and assembling, gaskets
1. 1. Unscre Unscrew th w the pis e piston r ton rod gu od guide ide and p and pull ull the pi the piston ston rod ou rod out of t of the cy the cylinde linder pip r pipe. e.
2. 2. Supp Support the ort the pisto piston rod in n rod in a vice a vice in the in the end th end that norm at normally s ally sits in th its in the stra e straddle ddle lift. U lift. Use se
protective jaws on the vice. protective jaws on the vice.
3. 3. Uns Unscre crew the nu w the nut and re t and remov move the ga e the gaske sket hol t holder w der with th ith the pist e piston sea on seals. ls.
Important! Important!
Before fitting, all seals should be lubricated with Before fitting, all seals should be lubricated with hydraulic oil. hydraulic oil.
4. 4. As Asse semb mble le in in th the e re reve vers rse o e ord rder er..
Figure 8.16 Figure 8.16 Stabiliser cylinder Stabiliser cylinder
06_004_A-Ergo_SidoStabHst dB.eps 06_004_A-Ergo_SidoStabHst dB.eps
https://www.besttruckmanuals.com/