ATLET A-Ergo, Service Manual

Page: 95 / 250

ATLET SERVICE MANUAL A-ERGO ATLET SERVICE MANUAL A-ERGO
Ma Mast st sy syst ste em / m / Re Rep pa aiir i r in nst strruc ucti tio on ns / s / D Diism sma an ntl tliin ng t g th he m e ma ast st 6 6..1 17 7
10. 10. Lift the inne Lift the inner mast str r mast straight up un aight up until the lowe til the lower thrust rol r thrust roller on the inn ler on the inner mas er mast and the t and the
upper thrust roller on the intermediate mast meet, and then pull upper thrust roller on the intermediate mast meet, and then pull the inner mast the inner mast
forwards to release it from the intermediate mast. If the ceiling is too low dismantle forwards to release it from the intermediate mast. If the ceiling is too low dismantle
the mast,
the mast, see "Dismantle the mast/straddle legs from the chassis" on page 6.8 see "Dismantle the mast/straddle legs from the chassis" on page 6.8, and , and
set it down. set it down.
11 11.. Remov Remove the upp e the upper retai er retaining sc ning screws for th rews for the side cy e side cylinde linders. rs.
12. 12. Lift out th Lift out the interm e intermediat ediate mast in th e mast in the same wa e same way as the in y as the inner mas ner mast. t.
13. 13. The tigh The tightenin tening torque bet g torque between the fram ween the frame and machi e and machine hous ne housing when refi ing when refitting tting
should be 277 Nm. should be 277 Nm.
Figure 6.20 Figure 6.20 Position for dismantling intermediate masts Position for dismantling intermediate masts
2 2
1 1
06_012_A-Ergo_ DelaMast.eps 06_012_A-Ergo_ DelaMast.eps
Tightening Tightening
torque:
torque:
27
277 7 Nm Nm
https://www.besttruckmanuals.com/