ATLET A-Ergo, Service Manual

Page: 113 / 250

ATLET SERVICE MANUAL A-ERGO ATLET SERVICE MANUAL A-ERGO
M Ma as st s t sy ys stte em / m / R Re ep pa ai r i r iin s n sttrru uc cttiio on ns / s / S Sttrra ad dd dlle l e li f i ftt 6 6..3 35 5
Straddle lift Straddle lift
Adjusting the straddle lift Adjusting the straddle lift
1. 1. Place Place the tr the truck o uck on a le n a level fl vel floor an oor and low d lower the er the forks forks and th and the ad e adjustab justable str le straddl addle lift. e lift.
2. 2. Check Check that that the di the distan stance be ce betwee tween the n the floor a floor and top nd top of th of the fork e forks corr s correspon esponds wi ds with th
table table 6.5 6.5 below. Measure at four points: below. Measure at four points:
- at each fork tip - at each fork tip
- at the
- at the back of the fork on each side back of the fork on each side
3. 3. Chec Check that k that the di the distanc stance is the e is the same same betwe between mas en mast and g t and guid uides. If n es. If neces ecessary a sary adjust djust to to
the same distance with the adjusting screws, both at the top and bottom. the same distance with the adjusting screws, both at the top and bottom.
4. 4. The lat The lateral eral play i play in the m n the mast sh ast should ould be ma be max 0-0 x 0-0.5 mm .5 mm. Bec . Because ause of the of the inexac inexactitude titude
in the linearity of in the linearity of the mast section a play of max 1.5 the mast section a play of max 1.5 mm is permitted at the mm is permitted at the “worst “worst
point”, raised or lowered. point”, raised or lowered.
This means that if for example the play is
This means that if for example the play is 0.5 mm with the straddle li 0.5 mm with the straddle lift raised, the ft raised, the
play with the straddle lift it play with the straddle lift it its lower position should be max 1.5 mm, and the its lower position should be max 1.5 mm, and the
reverse. reverse.
5. 5. Check Check the the play b play betwe etween the en the roller roller surfac surfaces on es on the the mast a mast and gui nd guides des. For . For permit permitted ted
play play see "Adjusting the play in the mast" see "Adjusting the play in the mast" on page 6.15 on page 6.15, 160 mast. , 160 mast.
6. 6. Ch Chec eck th k that at th the f e for orks ks ar are h e hori orizo zont ntal al..
7. 7. If the f If the fork ti ork tips po ps point up int upwards wards the s the shims o hims over th ver the pre e pressure ssure plate plate shou should be ld be remov removed ed
(on the assumption that the forks are straight). (on the assumption that the forks are straight).
8. 8. If the fo If the fork tips rk tips poin point dow t downward nwards shi s shims sho ms should b uld be add e added ov ed over the p er the pressu ressure pl re plate (on ate (on
the assumption that the forks are straight). the assumption that the forks are straight).
9. 9. When When the fo the forks are rks are para parallel, c llel, check heck the h the heigh eight. The t. The cylin cylinders c ders can be an be exten extended ded if it is if it is
not high enough. not high enough.
10. 10. T Test lift, and che est lift, and check that the ck that the straddle lift doe straddle lift does not lift ske s not lift skew w. If so, adjus . If so, adjust the length of t the length of
the cylinders until the best lifting movement is obtained. the cylinders until the best lifting movement is obtained.
11 11.. Check m Check measu easure, and if n re, and if neces ecessary mak sary make furth e further adjus er adjustments tments..
Figure 6.37 Figure 6.37 Positioning of shims Positioning of shims
06_011_A-Ergo_ShimH jSt.eps 06_011_A-Ergo_ShimH jSt.eps
https://www.besttruckmanuals.com/