Atest Gaz PW-072-A, User Manual

Page: 44 / 60

www.atestgaz.pl
Bit Flag Description
6 Gas_HiHi_Range Gas overload
7 Sensor_Lock Sensor lock (last measurement latched)
8 Calibration Calibration mode
9 Test Test mode
10 Warm_Up Sensor warming up
11 Sensor_Inhibit Inhibit mode
12 Comm_Error Detector communication error
13 Calibration_Warning Calibration time out (non-critical failure)
14 Measure Detector takes measurements
15 System_Stop System stopped
N – gas concentration. Value 0 correspond to 0 concentration, value 1000 corresponds to detector
maximum range.
6.1.2 Output status and DI1 – DI2 input status (read only)
Register Name Description Type / range
40065 DO_Status Control Unit output status. Specific bit description
bit 0 – state of R1 relay
bit 1 – state of R2 relay
bit 2 – state of R3 relay
bit 3 – visual indicator output
bit 3 – acoustic indicator output
bit 4 – FAULT relay
bit 5 – 15 – unused (can show any values)
value 0 – inactive output
value 1 – active output flags
40066 DI_Status Control Unit input status. Specific bit description
bit 0 – DI status
bit 1 – 15 – unused (can show any values)
value 0 – inactive input
value 1 – active input flags
6.1.3 Control Unit status (read only)
Register Name Description Type / range
40067 CU_Status
Control Unit module status
flags
CU_Status – Control Unit module status. For specific bits description see the table below.
Bit Flag Description
0 System_fail Collective system failure
1 CU_fail Control Unit module failure
2..15 - Unused – always zero
Atest Gaz A. M. Pachole sp. j.
ul. Spokojna 3, 44-109 Gliwice, Poland
VAT No.: PL 9691433231
tel.: +48 32 238 87 94
fax: +48 32 234 92 71
e-mail: contact@atestgaz.pl
Appendix: PU-Z-062-ENG R06
p. 5|8
•