www.atestgaz.pl
Option
Description
5. Set time
This option allows to set the date and time.
6. Language
It allows users to choose user’s interface language. Available languages include:
• Polish,
• English.
7. Level 1 password
It makes it possible to change access password for access level 1.
Pay special attention while changing access password for access level 1.
Entering a new password after losing the old one will be possible after
logging on to access level 2 or by the manufacturer's service
8. Level 2 password
It makes it possible to change the access password for access level 2.
Pay special attention while changing access password for access Level 2. Only
manufacturer’s service will be capable of entering a new password after
losing the old one.
9. Buzzer settings
It allows users to change internal buzzer settings. The following parameters can be changed:
(see section 5.11):
• buzzer recovery time for an alarm,
• buzzer recovery time for a fault,
• buzzer disabled permanently.
10. Display settings
It allows users to set a display contrast level.
11. Detector settings
It allows users to configure the number of detectors in the gas detection system. The user is
requested to enter this number ranging from 1 to 20. Subsequent network addresses
starting from 1 are assigned to subsequent Control Unit detector channels. Make sure that
detectors connected to the Control Unit have subsequent addresses from the pre-set range.
12. Output settings
It is possible to configure Control Unit outputs. After choosing this option, the user is
requested to select an output to be configured, and then to enter operation parameters for
this output. Parameter information – see section 4.2 and 4.4.
13. DIs settings
It allows users to configure the input as ALARM or FAULT.
14. Extension Module
settings
It allows users to configure Extension Module installed in the Control Unit (see also section
4.7). This option is available only, when the Extension Module is installed.
The type and range of parameters depends on the type of Extension Module – see Extension
Module manual for their descriptions (see section 13).
15. Log off
It returns to the basic setting level (level 0) – see also section 5.3.
Table 13: Control Unit menu
5.10
Events history
The device registers events related to the system operation (alarms, failures or information events, e. g.
inhibit mode). A specific event is connected with its time of occurrence.
Event history allows to store 4 000 records (in case of space used the oldest events are overwritten by new)
and can not be deleted.
It is possible to save event history directly to a file (using the Sigma Toolbox software).
p. 27|38
User's Manual: POD-026-ENG R17
