ATEN VM0808HA, User Manual

Page: 44 / 98

VM0808HA User Manual
32
IR Remote Control Operation
The IR remote control ( IR Remote Control , page 7) included with the
VM0808HA can be used to:
Š change the Input source of any Output display
Š power on/off individual Output displays; or
Š power on/off all Output displays simultaneously
Before using the remote control, a user must first plug the IR External Receiver
into the rear panel of the VM0808HA and place the receiver where the IR
signal can be reached (see
External IR Receiver Port , page 6).
Change the Input source of an Output display
To change the Input source of an Output display, using the remote control, do
the following:
1. Press the Output port number ( 1–8 ) you want to change.
2. Within 2 seconds press the Input port number ( 1–8 ) you want the Output
port to display.*
3. Repeat steps 1-2 to change additional ports.
*For the change to occur the Input number must be pressed within 2
seconds of pressing the Output number.
Power on/off individual Output displays
To power on/off individual Output displays, using the remote control, do the
following:
1. Press the Output port number ( 1–8 ) you want to power on/off.
2. Within 2 seconds press the ON or OFF pushbutton.*
3. Repeat steps 1-2 to change the power status back on/off.
*If the ON or OFF pushbutton is pressed after 2 seconds of pressing the
Output port number, all the displays are powered on or off instead of just
the intended Output port.