ATEN VM0808HA, User Manual

Page: 31 / 98

Chapter 3. Front Panel Configuration
19
Output Port Selection
Use the Output Port pushbuttons to select the Output port you want to
configure.
To select which output display corresponds to each input source device, do the
following:
1. Press any Output port pushbutton (1–8).
In the example below, Output port 1 pushbutton has been pressed.
Available Input ports light up. Because no Input LEDs are flashing, Output
port
1 is not tied to any Input port.
2. If an Output port pushbutton is pressed a second time, it is deselected and
the LED turns off.
3. To connect the selected Output port(s) to an Input port, press the Input port
pushbutton to which you want the Output port(s) tied. The newly selected
Input port LED flashes (0.5 sec on, 0.2 sec off), and the LCD information
is updated.
In the example below, pressing Input port
2 ties it to Output ports 2 , 3 and
4 .
INPUT 1 2 5 5 1 1 3 4
OUTPUT 1 2 3 4 5 6 7 8