AT&T MERLIN LEGEND Release 2.0 Analog Multiline Telephone, System Programming Manual

Page: 293 / 794

Programming Procedures
■
T316 Timer – times the delay in network response when the system
sends a restart message to clear a B-channel
NOTE:
If you enter an invalid timer value, the number you enter is truncated to the
closest valid value. For example, if you enter 45 for a counter that ranges
from 0-30, 4 is recorded.
The following table shows the factory setting for each timer and counter and the
valid range for each threshold.
Entering Programming
Console: Select Menu
→
Sys Program
→
Exit
PC/SPM: Type
SPM
→
press any key
→
[F1]
→
[F5]
Exiting Without Changes
To exit from any screen without making changes, select
Exit
on the console or
press
[F5]
on the PC before saving your entry or menu selection.
Summary Timers and Counters
Programmable by System manager
Mode All
Idle Condition Not required
Planning Form Form 3b, Incoming Trunks — DS1 Connectivity (100D
Module)
Factory Setting See Table 3-2
Table 3-2. Timers and Counters
Timer/Counter Setting
Factory Setting Valid Range
T200 Timer
T203 Timer
N200 Counter
N201 Counter
K Counter
T303 Timer
T305 Timer
T308 Timer
T309 Timer
T310 Timer
T313 Timer
T316 Timer
Maximum response time
Maximum time
Maximum transmissions
Maximum octets
Maximum outstanding
l-frames
Setup timeout
Disconnect timeout
Release timeout
Signal loss
Call Proc. timeout
Connect timeout
Restart timeout
1 second
30 seconds
3 transmissions
260 octets
7 frames
4 seconds
4 seconds
4 seconds
90 seconds
10 seconds
4 seconds
120 seconds
1000 - 3000 ms
1-60 seconds
1 – 5 transmissions
16-260 octets
1-15 frames
4-12 seconds
4-30 seconds
4-12 seconds
30-120 seconds
2-10 seconds
4-12 seconds
30-120 seconds
3-202 Timers and Counters