AT&T MERLIN LEGEND Release 2.0 Analog Multiline Telephone, System Programming Manual

Page: 549 / 794

Programming Procedures
Recall Timer
Use this procedure to designate the length of the timed flash that is sent when
Recall is used to disconnect a call and get a new dial tone without hanging up.
The interval of the timed flash and how Recall works depend on the type of
telephone and system operating mode.
The Recall Timer should be reset if multiline telephone users experience either
of the following problems:
When the user presses the Recall button on an outside call, nothing
happens. This indicates that the interval is too short and should be
increased to 650 milliseconds or 1 second.
In a system operating in Behind Switch mode, when the user presses the
Recall button on an outside call, the call is disconnected. This indicates
that the interval is too long and should be decreased to 350 milliseconds.
Entering Programming
Console: Select Menu
→
Sys Program
→
Exit
PC/SPM: Type
SPM
→
press any key
→
[F1]
→
[F5]
Exiting Without Changes
To exit from any screen without making changes, select
Exit
on the console or
press
[F5]
on the PC before saving your entry or menu selection.
Summary: Recall Timer
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System manager
All
Not required
Form 6f, System Features
450 ms
350 ms, 450 ms, 650 ms, 1 second
No
No
Options
→
More
→ →
Select RecallTimer
→
Select
time
→
Enter
→
Exit
[F7]
→
[PgUp]
→
[F3]
→
Select time
→
[F10]
→
[F5]
3-458 Recall Timer