Programming Procedures
Toll Type
Entering Programming
Use this procedure to specify whether users have to dial a toll prefix (1 or 0
before dialing an area code and telephone number. (Your local telephone
company should verify toll prefix requirements for each trunk. )
This setting is used by the system to classify calls as local or long distance so
that toll restrictions can be applied as appropriate.
NOTE:
This option applies only to loop- and ground-start trunks; it does not apply
to tie trunks or DID trunks.
Console: Select Menu
→
Sys Program
→
Exit
PC/SPM: Type
SPM
→
press any key
→
[F1]
→
[F5]
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
press
[F5]
on the PC before saving your entry or menu selection.
Summary: Toll Type
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
†
System manager
All
Not required
Form 2c, System Numbering - Trunk Jacks
Toll prefix required
Required, not required
N o
Yes
To program a single telephone:
Lines Trunks
→
Toll Type
→
select entry mode
→
Dial no. Of the line
→
Enter
→
Exit
→
Exit
→
To program a block of telephones:
LinesTrunks
→
Toll Type
→
Select block of lines
→
Toggle LED On/Off
→
Enter
→
Exit
→
Exit
†
Entry mode available
Toll Type
3-65
Summary of Contents for MERLIN LEGEND Release 2.0 Analog Multiline Telephone
