Asymtek C702, Student Manual

Page: 53 / 82

Level 2 Maintenance Training, Century Series 3-3 P/N 73-0028-00 Revision A
Level 2 Module 3
STUDENT GUIDE
LESSON 1 The Needle Sensor, CONTINUED
Needle Sensor Adjustments
There are three procedures that involve Needle Sensor Operation:
•
Calculate Master Offsets
•
Find Needle XYZ
•
Setup Parameters
EXERCISE 3-1 Calculate Master Offsets
1. Click CONFIGURATION from the Main Window.
2. Select NEEDLE SETUP.
3. Select CALCULATE MASTER OFFSETS.
4. Check to make sure that the Load Cell in the NSZ Series is clean.
5. Clean with a cotton swab if necessary.
6. Follow the on-screen prompts.
EXERCISE 3-2 Find Needle XYZ
1. Select SETUP in the Programming Window.
2. Select FIND NEEDLE XYZ.
3. Follow the on-screen prompts.
EXERCISE 3-3 Needle Parameters
1. Click CONFIGURATION from the Main Window.
2. Select NEEDLE SETUP.
3. Select SETUP PARAMETERS.
4. Click the arrow next to the Sensor Type dialog box to view the available options.
5. Choose the appropriate sensor model for your system.
6. Click OK.
EXERCISE 3-4 Cleaning the Needle Sensor
1. Use an air gun or air blowing hose attachment to blow any dust off of each sensor.
2. Depending on your system configuration there may be as many as three sensors present.