ASTRO WM-3209, Instruction Manual

Page: 134 / 254

122
･
Adjusting the Checker level
Turn the adjustment dial, and adjust the size of checker pattern.
The parameter is 0 to 16, 0 will be the minimum size and 16 will be maximum size.
When 0 is set for Level, the Another CH characters are highlighted; when 16 is set for
Level, the Owner CH characters are highlighted.
By pressing adjustment dial, setting will switched to level 16 (Owner CH), level 8
(horizontal division at the center into two equal parts) and 0 (Another CH) in order.
For details, refer to "5.19 Concerning 3D image alignment."
･ Anaglyph
The Owner CH image (left eye image) is output in the "GB" colors; the Another CH image
(right eye image) is output in the "R" color.
Three-dimensional images can be viewed through 3D eye-glasses which use R (red) for
the left eye and C (cyan) for the right eye.
For details, refer to "5.20 Concerning checking 3D image using the anaglyph system."
･
Y-Difference (brightness difference display)
The difference in the brightness levels of the Owner CH image (left eye image) and
Another CH image (right eye image) is displayed in monochrome.
When Owner CH > Another CH, the brightness difference is displayed in shades of gray
toward white.
When Owner CH = Another CH, the brightness difference is displayed in a mid-value
shade of gray.
When Owner CH < Another CH, the brightness difference is displayed in shades of gray
toward black.
For details, refer to "5.22 Concerning the brightness difference display function."
･
Marker (L and R difference measurement)
Display two markers for measuring the difference of L and R image.
When the marker function is enabled, WM-3209 will measure the difference between two
makers.
The measurement result will be displayed with pixel or percentage compared to total H
Active.
The Image difference simulation is available with 2 sample display size. Display size will
be able to customize from 10 inch to 1000 inch.
In the Bottom left, active marker status is shown by high lighting the active marker.
Markers are movable by rotating the adjustment dial.
・ Supplementary notes
The MAG function setting is reflected in Picture Mode 2 and Compare Mode 1.
For details, refer to "4.3 Picture Mode 2" ana “4.12 Compare Mode 1.”