ASTRO-MED QLS-2000XE SERIES, Operation & Setup Manual, Page: 61 / 214

QLS-3000/2000 Xe Series 3-25
Comm Menu
Port
The comm port in use (parallel or RS-232) must be selected to enable
communications. If RS-232 is used, baud rate can also be selected. The
default comm port is parallel.
Note: Serial communications are required to enable status messages to be
received from the printer (bi-directional communications).
If using both parallel and RS-232 serial communications, select and set up
RS-232 first, then select and set up parallel communications.
If using RS-232 serial communications, the printer uses 2 stop bits.
To select comm ports:
1 Press the MENU key. Use the arrow keys to select Comm from the menu
and then press the SELECT key.
2 In the COMM menu, use the arrow keys to select Port. Then press the
SELECT key.
3 Use the up/down arrow keys to specify the type of port being used.
Parallel or RS-232 ports are available. Press the SELECT key.
A confirmation message will appear on the display.
4 Use the left/right arrow keys to select YES, then press the SELECT Key.
Change Comm parameters permanently?
>
NO YES
(COMM) > Port | Hshk | Ptcl | Pref | Delim
Port: Parallel
| Intensity | Print | Memory | Mode |
| Align | Media
| > Comm | System |