Asentria SiteBoss 530 User Manual
17
Event Sensor Report To Port
sets the TCP Port that a sensor connected to this S530 would use to report to a host
S530.
Enable EventSensor Reporting Host
is an ON/OFF toggle to enable this S530 to be a host for EventSensor
reporting from another Asentria device.
EventSensor Reporting Host Port
sets the TCP Port that this S530 will use for receiving sensor reports from
another Asentria device.
For a further explanation of EventSensor Reporting, refer to the
chapter.
SNMP Settings
iteBoss 530 - SNMP Settings
A) SNMP Agent Enable [ON]
B) Read Community [public]
C) Write Community [public]
D) Trap Community [public]
E) Trap Settings
F) Security Method [MD5-DES]
SNMP Agent Enable
toggles between ON and OFF, and controls whether the unit responds to SNMP ‘gets’ and
‘sets’. Default setting is ON.
Note:
SNMP Agent Enable does NOT stop SNMP traps from being sent when it is set to OFF.
Read / Write / Trap Community
sets the SNMP trap communities to use. Default setting for all is PUBLIC. (Max
length for each is 23 chars)
displays a menu that allows you to configure whether to send authentication failure traps, and
Notification settings. Settings previously in this menu (Include Data and Time, Include Site Name, Include Sensor ID,
Include User Defined Name and Include User Defined State) have been moved to the Alarm/Event Definitions/Event
Message Settings menu because these settings now apply to more actions than SNMP traps.
Security Method
toggles between MD5-DES and SHA-AES to controls whether MD5 and DES, or SHA-1 and AES,
are used for authentication and privacy, respectively, for for SNMPv3 get/set/trap operations. Default setting is MD5-
DES. (Note – this option is currently displayed in this menu, but will be removed in the next firmware version release
because the S530 does not support SNMP v3.)
Trap Settings
SiteBoss 530 - Trap Settings
A) Authentication Failure Traps [OFF]
B) Notification Attempts (0=infinite) [5]
C) Notification Timeout (seconds) [60]
D) Notification Cycles (0=infinite) [10]
E) Notification Snooze Period (minutes) [60]
F) Notification Security Name []
G) Notification Security Password [********]
Authentication Failure Traps
is an ON/OFF toggle to enable the sending of authentication traps, which are
notifications of invalid community name usage in SNMP operations. Default setting is OFF.
Notification Attempts
sets the number of attempts (1 to 65535) of sending a notification (trap/inform) per cycle (that
is, the initial a retries). If this is 0 then there is 1 infinite cycle. Default setting is 5.
Summary of Contents for SiteBoss 530
Page 6: ......