Ascon tecnologic KM2, Engineering Manual

Page: 33 / 40

Ascon Tecnologic - KM2 Line - ENGINEERING MANUAL -
PAG. 33
]
AL3 group - Alarm 3 parameters
no. Param. Description
Dec.
Point
Values Default
41
AL3t
Alarm 3 type 0
nonE Alarm not used;
LoAb Absolute low alarm;
HiAb Absolute high alarm;
LHAo Windows alarm in alarm outside the windows;
LHAi Windows alarm in alarm inside the windows;
SE.br Sensor Break;
LodE Deviation low alarm (relative);
HidE Deviation high alarm (relative);
LHdo Relative band alarm in alarm out of the band;
LHdi Relative band alarm in alarm inside the band.
nonE
42
Ab3
Alarm 3 function 0
0... 15:
+1 Not active at Power ON;
+2 Latched alarm (manual reset);
+4 Acknowledgeable alarm;
+8 Relative alarm not active at Set Point change.
0
43
AL3L
For band alarm, it is low alarm threshold dp From -1999 to AL3H (E.U.) -1999
44
AL3H
For band alarm, it is high alarm threshold dp From AL3L to 9999 (E.U.) 9999
45
AL3
AL3 threshold dp From AL3L to AL3H (E.U.) 0
46
HAL3
AL3 hysteresis dp 1... 9999 (E.U.) 1
47
AL3d
AL3 delay 0
0 oFF (disable)
1... 9999 (s)
oFF
48
AL3o
Alarm 3 enabling during Stand-by mode and
in over or under range conditions
0
0 Alarm 1 disabled during Stand by and out of range
conditions;
1 Alarm 1 enabled in stand by mode;
2 Alarm 1 enabled in out of range conditions;
3 Alarm 1 enabled in stand by mode and out of range
conditions.
0
]
HBD group - Heater Break Down Parameters
no. Param. Description
Dec.
Point
Values Default
49
Ct.So
Current Transformer signal source 0
OFF HBD not used;
nonE Asynchronous amperometer;
out3 Synchronous to Out 3;
out2 Synchronous to Out 2;
out1 Synchronous to Out 1.
oFF
50
Ct.dF
Current measure decimal point 0 0, 1 or 2 10
51
Ct.rA
CT end of scale Ct.dF 1... 999 (A) 20
52
Ct.FL
Filter on the CT measure 0
no Filter disabled;
YES Filter enabled.
no
53
Ct.LA
HBD alarm function 0
0 Automatic reset;
1 Manual reset;
2 Acknowledgeable alarm.
54
Ct.Ld
CT threshold with output ON Ct.dF oFF
Threshold disabled (inhibited);
1... 999 (A)
55
Ct.LE
CT threshold with output oFF (leakage) Ct.dF oFF
Threshold disabled (inhibited);
1... 999 (A)
56
Ct.oc
Overcurrent Ct.dF oFF
Threshold disabled (inhibited);
1... 999 (A)
]
rEG group - Control Parameters
no. Param. Description
Dec.
Point
Values Default
57
cont
Control type when at least one
heating output and one cooling
output are configured
0
Pid PID control;
nr ON/OFF control with neutral zone.
Pid
Control type when the outputs are
configured for heating or cooling
0
Pid PID (heat and/or);
On.FA ON/OFF asymmetric hysteresis;
On.FS ON/OFF symmetric hysteresis.