ASCOM Ascotel 2025, System Manual

Page: 715 / 1141

ascom Ascotel 2025/2045/2065
3.84 Planning DECT Systems HBT_20321104_03/B0_en
Typical Procedure
• Install test radio unit A in the first position according to the plan and connect
the plug-in power unit, provided a 230 VAC connection is available (if not, use
the battery box).
• Set the standard handset to the Look-Around mode:
– Press the "M" key repeatedly until "Test" appears
– Press the Foxkey at "Look"
A list of radio units appears:
• Top line: Identification, last digit – field strength in dBµV
• Bottom line: "go" (Foxkey), starts the measurement
Selected radio units / number of visible radio units "
¥
", selection of radio units
(scrolling)
This display is used to provide an overview of the radio units to be received.
• To display only the field strength of radio unit A, you need to select A from the
list:
– Press the "M" key
– Press the Foxkey repeatedly at "
¥ " until the identification corresponding to
radio unit A appears on line 1.
– Then press "Tick"; a dot appears next to "Tick".
– Press the "M" key
The field strength of radio unit A appears
– Press the Foxkey at "go": The measurement starts.
Check:
The measured value should be >60 in the immediate vicinity of the test radio unit.
• Display radio units A and B:
– Press "M" -- back to the overview
– Press "M" -- Tick mode
– Tick radio unit B
– Press "M" and then the Foxkey at "go" -- both radio units are displayed.
The field strengths of A and B can now be measured simultaneously and entered
on the plan.