ASCOM Ascotel 2025, System Manual

Page: 1079 / 1141

ascom Ascotel 2025/2045/2065
7.80 Operations Supervision HBT_20321104_07/B0_en
4.6.8 CL Malfunctions
Tab. 7.35: CL malfunctions
4.6.9 Malfunctions with the teleCOURIER 900 Pager System
(PS)
Tab. 7.36: Malfunctions with the PS
Error description Error cause / error handling
Operator Console charges not transferred to next
subscriber. A different terminal selection digit was probably set
on the Operator Console. This means the terminal is
logged on in the PBX with the new terminal selection
digit.
• Unplug the Operator Console, then reconnect it
after a few seconds
The event message "CL printer jam" appears and
cannot be cleared. This means that after approx. 100
calls none of the subscribers will be able to make
outgoing phone calls as the exchange output will be
barred by the emergency digit barring. If the printer is OK, the OCL / ICL memory may be
full. To clear it, proceed as follows:
• V.24 mainboard: Set "–" mode
• This measure will result in the loss of stored printer
data.
The event message "ICC OVERFLOW" appears and
the ICC data is given the prefix "+". Charge counter has reached maximum value of
2,147,483 and begins at zero again
• Print out or clear the counter
Printer is blocked (paper jam, out of paper):
• Clear printer and reset.
No more ICL data is output via the V.24. Memory overflow if the ICL printer is blocked (the
same memory is used).
• Clear the printer jam or, if necessary,
• Clear the OCL / ICL memory (see above)
Error description Error cause / error handling
Paging system (PS) does not work. • Check whether the PS has been configured
The PS receivers continue to ring after answering
(several search paths). The search duration t
r
is set too short in the AIMS
configuration. t
r
must be
³
the search duration set in
the PS.
• Adjust the search duration t
r