23
Replace Disinfectant Bottle
(10 steps)
1
Put on protective glasses and gloves.
2
Open the access door on the left side of the panel.
(See Fig. 1)
3
Disconnect the suction part (
A
) from the disinfectant bottle.
4
Discard the old bottle and replace with a new ArjoHuntleigh
Disinfectant bottle.
5
Connect the suction part (
A
) to the new bottle.
6
Grab the disinfectant spray handle, and direct it against the
bottom of the bathtub.
7
Press the Disinfection button on the control panel. The LED
lights when the disinfection is activated.
8
Adjust water temperature so it reaches approximately 25 °C
(77 °F) to eliminate disinfectant fumes.
9
Spray disinfectant in the bathtub, keeping an eye on the flow
meter so it is in accordance with the setting range due to the
mix ration table below.
(See Fig. 2
)
10 If necessary, adjust the bottle cap by hand to get correct mix
ratio.
(See Fig. 3)
Disinfectant
Flow Meter Mix
Ratio
General Purpose Disinfectant
30
Arjo Clean™
60
Arjo Disinfectant Cleanser IV
30
Cen-Kleen IV™
30
Fig. 1
A
Fig. 2
e.g. Arjo Clean™
(60)
Fig. 3
