55
11. Install the front body panel; then install the front rack
and splash panels (see Steering/Frame/Controls).
STATIC INJECTOR TIMING
To set static injector timing, use the following procedure.
1. Remove the valve cover and fuel rail (see Unit Injec-
tors in this sub-section).
2. Install the Fuel Injector Timing Tool on the injector
using the eccentric gasket over the check valve in
place of the O-ring.
DE572
DE444A
3. Connect a suitable container filled with clean diesel
fuel to the supply fitting using an inlet hose; then
place a small cup under the bleed hose.
DE403B
4. Rotate the engine in the direction of rotation (clock-
wise) until the #2 (flywheel-side) piston is at top-
dead-center (TDC) on the compression stroke (refer-
ence mark (D) aligned to TDC index mark (A) and
valves closed).
DE557A
5. Raise the fuel container above the level of the injec-
tor; then rotate engine counterclockwise until refer-
ence mark (D) is to the left of the 13° BTDC mark
(B) or until fuel is observed flowing from the bleed
hose.
DE560A
DE403A
6. Rotate the engine clockwise and stop immediately
when the fuel stops flowing. This indicates the
beginning of injection.
