15
3. Pinch the V-belt together near its center and slide the
movable drive face onto the drive hub. Secure the
drive face with a nut (threads coated with red Loctite
#271). Tighten the nut to 85 ft-lb.
DE483
NOTE: At this point, the cap screw can be removed
from the fixed driven face.
4. Rotate the V-belt and pulley until the V-belt is flush
with the top of the driven pulley.
5. Install the cap screw securing the drive clutch assem-
bly to the flywheel/PTO shaft and tighten to 40 ft-lb.
6. Place the V-belt cover gasket into position; then
install the cover and secure with the cap screws.
Tighten to 9 ft-lb.
CD083
7. Secure the front fender to the footrest with the two
cap screws. Tighten securely.
8. Install the right-side footrest (see Steering/Frame/
Controls).
Fuel Filter
This diesel-powered ATV is equipped with a high effi-
ciency fuel filter. The fuel filter should be changed in
accordance with the maintenance schedule or more often
if operated under severe conditions or winter operation.
To change the fuel filter, use the following procedure.
1. Remove the right front fender splash panel; then
using an appropriate filter wrench, remove the fuel
filter.
2. Apply a light coat of oil to the seal ring of the new
fuel filter; then install the filter. Tighten until the seal
ring contacts the filter head; then tighten an addi-
tional 3/4 turn.
DE032D
3. Depress and release the manual primer pump to
charge the fuel filter and purge any air from the sys-
tem.
DE031A
NOTE: Cycle the manual primer pump until the lever
becomes firm and resistance is observed. The sys-
tem will bleed itself through the tank return circuit.
4. Check for any fuel leaks; then start the engine and
check for normal engine operation.
