36
DE090A
9. Block the rear of the engine up; then remove the rear
mounts from the transmission.
10. Remove five cap screws securing the transmission to
the V-belt housing; then remove four cap screws
securing the engine-to-transmission mounting plate.
DE589A
DE487
11. Slide the transmission to the left side until the rear out-
put flanges can be separated; then move the transmis-
sion to the rear to expose the front output yoke boot.
12. Slide the boot off the yoke and separate the front pro-
peller shaft from the front output drive yoke.
Top-Side Components
NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
SPEED GOVERNOR
Removing/Disassembling
1. Remove the timing belt (see Left-Side Components
in this section).
2. Remove the air filter assembly; then remove the
valve cover.
DE682
3. Disconnect the throttle cable; then remove the cap
screws securing the intake manifold/throttle cable
housing to the cylinder head.
DE080A
DE248A
AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
