6-18
CD754
10. Using CV Boot Clamp Tool, secure both outside
boot clamps.
CD024
ASSEMBLING AXLES
1. Install the inner boot with the small clamp making
sure the ends of the clamp are positioned correctly.
NOTE: The boot is positioned correctly when the
small end of the boot seats down into the recessed
groove.
CD754
2. Using the boot clamp tool, secure the small clamp of
the inner boot.
ATV-1048
3. Apply 80 grams (2/3 of contents) of grease from the
pack into the bearing housing.
4. Install the bearing onto the shaft making sure the
recess of the bearing is facing the housing.
CD022
5. Secure the bearing ring with the snap ring making
sure the sharp side of the snap ring faces away from
the boot.
CD023
6. Making sure the marks made during disassembling
align, slide the housing over the bearing ring; then
completely seat the bearing ring into the housing and
install the snap ring.
CAUTION
The clamps must be positioned correctly or they
may loosen when in motion.
CAUTION
The bearing ring must go onto the shaft with the
side without splines facing toward the small clamp
of the inner boot or severe damage will result.
Manual
Table of Contents
