2-4
NOTE: The engine must be cold for this proce-
dure.
NOTE: The seat, seat back, seat base, and spark
plug must be removed for this procedure.
1. Remove the spark plug and timing inspection plug;
then remove the tappet covers (for more detailed
information, see Section 3 - Servicing Top-Side
Components).
2. Rotate the crankshaft to the TDC position on the
compression stroke.
NOTE: At this point, the rocker arms and adjuster
screws must not have pressure on them.
Feeler Gauge Procedure
Using a feeler gauge, check each valve/tappet clearance.
If clearance is not within specifications, loosen the jam
nut and rotate the tappet adjuster screw until the clear-
ance is within specifications. Tighten each jam nut
securely after completing the adjustment.
CC007D
Valve Adjuster Procedure
A. Place the Valve Clearance Adjuster onto the jam
nut securing the tappet adjuster screw; then rotate
the valve adjuster dial clockwise until the end is
seated in the tappet adjuster screw.
B. While holding the valve adjuster dial in place, use
the valve adjuster handle and loosen the jam nut;
then rotate the tappet adjuster screw clockwise
until friction is felt.
C. Align the valve adjuster handle with one of the
marks on the valve adjuster dial.
D. While holding the valve adjuster handle in place,
rotate the valve adjuster dial counterclockwise
until proper valve/tappet clearance is attained.
NOTE: Refer to the appropriate specifications in
Feeler Gauge Procedure sub-section for the proper
valve/tappet clearance.
NOTE: Rotating the valve adjuster dial counter-
clockwise will open the valve/tappet clearance by
0.05 mm (0.002 in.) per mark.
E. While holding the adjuster dial at the proper
clearance setting, tighten the jam nut securely
with the valve adjuster handle.
3. Install the spark plug; then install the timing inspec-
tion plug.
4. Place the two tappet covers with O-rings into posi-
tion. Tighten the cap screws securely.
Testing Engine
Compression
To test engine compression, use the following procedure.
NOTE: The engine should be warm (operating
temperature) and the battery fully charged for an
accurate compression test. The throttle must be in
the wide-open throttle (WOT) position. In the event
the engine can not be run, cold values are
included.
NOTE: The seat, seat back, and seat base must
be removed for this procedure.
1. Remove the high tension lead from the spark plug.
2. Using compressed air, blow any debris from around
the spark plug.
3. Remove the spark plug; then attach the high tension
lead to the plug and ground the plug on the cylinder
head well away from the spark plug hole.
4. Attach the Compression Tester Kit.
5. While holding the throttle in the full-open position,
crank the engine over with the electric starter until
the gauge stops climbing (five to 10 compression
strokes).
CAUTION
The feeler gauge must be positioned at the same
angle as the valve and valve adjuster for an accurate
measurement of clearance. Failure to measure the
valve clearance accurately could cause valve com-
ponent damage.
VALVE/TAPPET CLEARANCE
Intake
0.1016 mm (0.004 in.)
Exhaust
0.1524 mm (0.006 in.)
! WARNING
Always wear safety glasses when using compressed
air.
PSI Hot (WOT)
PSI Cold (WOT)
125-145
100-140
Manual
Table of Contents
