6-29
6
PR367C
INSTALLING
1. Remove the bearing cups from the universal joint;
then insert the joint into the yoke and install one
bearing cup on the joint.
PR368
2. Secure U-Joint Separator Tool in a vise; then place
the yoke, joint, and bearing cup into position and
press the cup into the yoke.
PR374
3. Install the retainer in the bearing cup; then remove
the yoke from the separator tool.
NOTE: Repeat steps 2-3 for the opposite-side
bearing cup.
4. Remove the separator tool from the vise and install
the universal joint, bearing cups, and movable yoke
into the fixed yoke using the same procedure as steps
2-3 except the vise cannot be used.
PR355
5. Check that the universal joint can be flexed freely
without binding; then apply multi-purpose grease to
the splines and install the driveshaft noting the match
marks made prior to removing.
CAUTION
Care must be taken when installing bearing cups
that the needle bearings stay in place or severe dam-
age to the universal joint will occur.
Manual
Table of Contents
