Arbiter Systems 931A, Operation Manual

Page: 55 / 161

Review Method
1. Use the up and down arrow keys to select a record to be cleared or
reviewed
2. Press ENTER to view the highlighted record. After pressing
ENTER, the unit goes into measurement hold mode and the stored
record overwrites the current data. See Section 3.10 for further in-
formation on data logging and reviewing. Press MEASURE/HOLD
to release the instrument from the measurement hold mode.
3. When in the selection menu display, press the left arrow key to clear
the highlighted record from memory.
4. To remove all data records from memory, press ENTER when Clear
All Entries is highlighted.
5. Press escape to return the instrument to normal operation with out
any modification of stored data.
3.3.2.15 Print Log
PRINT
PRINT LOG
Press SHIFT then PRINT LOG to print to a list of the stored
records to printer or computer connected to the serial interface
(RS-232 port).
3.3.2.16 Store Setup
LAST SETUP
STORE SETUP
Use the STORE SETUP key to save the current instrument-
state in one of six memory registers: SETUP 1 through SETUP
6. Press SHIFT then STORE SETUP to produce the following
prompt on the display:
Press SHIFT and desired SETUP key to store current instrument-state.
Press SHIFT, followed by one of the six SETUP keys (highlighted in
gray across the top row) to store the current instrument setup into the
corresponding register (SETUP 1 through SETUP 6). All setups are stored
in non-volatile memory. For instructions on recalling instrument setups,
see Section 3.3.2.2.
3.3.2.17 Scale
CH1 / CH2
SCALE
Use the SCALE key to apply individual Scale Factors to each AC
measurement input function. Scale Factor corrections can adapt
the Model 931A for use with current or potential transformers.
39