Arbiter Systems 931A, Operation Manual

Page: 144 / 161

B.1.3 Current Display
To display the input current reading directly on the Model 931A, press
SHIFT, then SCALE and set the CT value to “20,” and set PT/CT to
“ON.” Refer to Section 3.3.2.17 for details on setting Scale Factors.
B.2 Handle/Bail
This section contains information and procedures for installing the optional
handle/bail onto the Model 931A case.
B.2.1 Parts and Accessories
Included with the installation kit are the following components:
Description Qty Arbiter P/N
Mounting Bracket 2 HD0049800A
Handle/Bail 1 HD0049900A
Fastener Knob 2 HP0014200A
B.2.2 Required Tools
The only tool required for installation of the bail is a 2.5mm Allen wrench.
B.2.3 Procedure
NOTE: Perform the following steps to attach a mounting bracket to one
side of the case. Repeat for the opposite side (see Figure B.1).
1. Remove the four existing M5 screws that hold the instrument to the
outer case.
2. Assemble Handle/Bail onto mounting brackets with the studs facing
out. Use the knobs provided.
3. Install assembled mounting bracket onto the case using the four M5
screws previously removed.
B.2.4 Operation
To move the handle/bail to different positions/locations (see Figure B.1)
simply loosen both fastening knobs, reposition handle and re-tighten
knobs.
128