ARAG Bravo 180S Series, Installation, Use And Maintenance Handbook

Page: 36 / 42

36
15 MAINTENANCE / DIAGNOSTICS / REPAIRS
15.1 Operation errors
Machine stopped!
0.0 MPH A
0.0 gpa
0.0 MPH A
The indicated messages blink alternatively
Fig. 97
Par.
JOB
MODE
MESSAGE ON DISPLAY /
CAUSE
REMEDY
13.2.2
MAN.
+
AUTO
Disable Main
Main switch ON upon computer switching on
• Move main switch downwards (position OFF).
13.2.2
14.3.1
AUTO
Machine stopped!
Main switch ON with machine stopped
• Start the farming machine.
• Move main switch downwards (position OFF).
14.3.1 AUTO
Missing flow!
Main switch ON with machine stopped but rate at zero
• Start the pump and move the farming machine.
11.10
14.3.1
AUTO
Slow down!
The rate does not reach the value required for output
• Decrease the farming machine speed.
• Check that the flowmeter constant value has been set correctly.
11.10
14.3.1
AUTO
Accellerate!
The flowrate exceeds the value required for output
• Increase the farming machine speed.
• Check that the flowmeter constant value has been set correctly.
11.12
14.5
MAN.
+
AUTO
Check sensor!
Faulty pressure values have been detected
• Check the pressure sensor status and make sure there is no residual pressure in
the system.
7.2
11.17
MAN.
+
AUTO
USB not found
The pendrive is not inserted correctly
• Turn off the computer and check the insertion of the pendrive.
--
MAN.
+
AUTO
Error!
• The pendrive is blocked • Switch off the computer and release the pendrive.
• The pendrive has not free space • Space needed for new information: delete the unnecessary files from the pendrive.
12.12
MAN.
+
AUTO
File not found (SETUP.BIN)
The computer configuration has not been saved
• Save the data.
11.17
MAN.
+
AUTO
File not found (TANK.TKL)
The tank configuration has not been saved
• Save the data.
11.17
12.12
MAN.
+
AUTO
Wrong file
• The file relevant to the computer configuration
(
SETUP.BIN
) is faulty.
• The file relevant to the tank configuration
(
TANK.TKL
) is faulty.
• Try to save the data again.
7.1
7.2
MAN.
+
AUTO
GPS timeout
• Wrong cable connection for receiver.
• The receiver connection cable is damaged
• The receiver is damaged • Check connection to receiver.
• Replace the cable.
• Replace the receiver.
MAINTENANCE / DIAGNOSTICS / REPAIRS