28
Par.10.2
Shifting
of the cursor
Quits the menu or
the data change
Confirms access to menu
or data change
Menu item scrolling or
Data increase/decrease
12.3
Minimum regulation pressure
*
Min. reg. press.
Disabled
Fig. 66
This menu allows setting a pressure value below which BRAVO 180S blocks the automatic regulation function
(
Disabled
: block disabled).
The control is active ONLY during treatment AUTOMATIC control (par. 14.3.1).
For the procedure to be followed in case of alarms, please refer to par. 15.1 Operation errors.
Pressure sensor
par. 11.12
Press. calc.
par. 11.14
* MENU VISIBLE ONLY WITH SPECIFIC SETTINGS:
TO VIEW IT, ENABLE ONE OF THE INDICATED OPTIONS
12.4
Wheel selection
**
Wheel 1/3
19.68in./pls
2
1
1
Type of wheel
Fig. 67
Once the wheel constants (max. 3) have been saved, they can be retrieved as selection of the wheel type.
As an alternative it is possible to retrieve the GPS source, only if it is enabled in the advanced setting.
The display will show only the types of wheel for which a constant has been set.
At least 2 types of
Wheel
par. 11.8
1 type of
Wheel
+
GPS source
par. 11.8
** MENU VISIBLE ONLY WITH SPECIFIC SETTINGS:
TO VIEW IT, ENABLE ONE OF THE INDICATED OPTIONS
12.5
Minimum speed
Minimum speed
Disabled
Fig. 68
BRAVO 180S interrupts the spraying when the detected speed is lower than the set one.
(
Disabled
: block disabled).
The control is active ONLY during treatment AUTOMATIC control (par. 14.3.1).
For the procedure to be followed in case of alarms, please refer to par. 15.1 Operation errors.
12.6
Rate correction
When using a paddle flowmeter and the sprayed fluid has a different density than the water one, the computer could display wrong measurements;
to correct them change the sprayed fluid factor:
• if at the end of the spraying the tank still contains fluid, reduce the factor;
• if the fluid finishes before the job has ended, increase the factor.
Rate correction
1.00
Fig. 69
Set the density factor of the sprayed fluid.
Flowmeters of the ORION series (code 462xxx) are not affected by the density difference of the fluids: set
the factor to 1.00.
USER SETTING
Summary of Contents for Bravo 180S Series
Page 41: ...Notes 41...