Aquasafe WSL50 Pro, Instruction Manual

Page: 24 / 193

3.3.4 37°C Program (Fig 1.2)
This mode is the pre-programmed default 37°C incubation cycle. In this mode the
incubator will run an 18-hour incubation cycle at 37°C. The timer can be altered
to any setting between 0 and 24 hours. Adjusting the incubation time is
described in section 3.3.8. Pressing and holding the middle switch for 5 seconds
will start the incubation cycle and the display will change to the following:
The asterisk preceding the temperature will switch on and off indicating the
status of the heater. To stop or pause the incubation cycle press and hold the
middle switch again for 5 seconds. The display will show the following:
Pressing and holding the middle switch will restart the cycle or pressing the left
switch will return to the menu function screen. During the run mode a short
press of the middle switch will indicate the battery voltage. For best accuracy
always check the battery voltage when the heater is off (when the asterisk is not
displayed). Once the chamber has reached the pre-set temperature the timer will
start to countdown. If for any reason the temperature should drop, such as
power failure, the timer will auto pause until the temperature is back to the pre-
set temperature. It should also be noted that if there is a power failure the timer
will reset back to the nearest hour. So, a reset at 17:35 would result in a reset to
17:00. The timer displayed is a countdown timer so it will display the time left not
the elapsed time. When the timer reaches 00:00 a buzzer will sound
intermittently and the display will display done A where A is the left chamber.
20.9°C 20.9°C
->37°C MEM OFF
*20.9°C 20.9°C
18:00 RUN! 24:00
*36.9°C 20.9°C
18:00 MEM 24:00