SmartLine Management Software
5-17
When you select a lobe or RI/RO port, you get the following:
Port Status
Wrapped (No cable attached) or Inserted (cable
connected)
Port
Locked or Unlocked status
Auto Loop
On (enabled) or Off (disabled) for RI/RO port
status
Media
UTP (RJ45 connectors used) or STP (DC
connectors used)
Speed Detect
Enabled or Disabled
When you select the DIP Switch, you get the following status:
Port Speed
4- or 16-megahertz setting for chassis
Phantom
Detected (wire fault option also available) or Not
Detected
Controlling Access by Locking Ports
1. Select the individual port or chassis (all ports) that you wish to Lock
or Unlock.
2. Select Lock or Unlock from either the Control menu or Button Bar. A
confirmation box then appears allowing you to cancel or proceed. The
LEDs for Locked ports turn red. The LEDs for Unlocked and inserted
ports turn green. If a lobe port LED is off, the workstation is either
powered off or disconnected. A red flashing lobe LED indicates a
workstation operating at the wrong speed.
