![background image](http://html1.mh-extra.com/html/amx/modero-cv7/modero-cv7_operation-reference-manual_2939251034.webp)
CV7 Touch Panel Accessories
22
7" Modero Touch Panels
3.
Press the outer housing forwards until it is aligned over the outer housing installation holes. Once
installed and secured, the tilt bracket prevents any further movement (FIG. 18).
4.
Gently press down on the housing (toward the base) until it is securely positioned over the circuit board
and base.
5.
While holding the circuit board cover in place, turn the panel back over until the LCD lies facedown on a
soft cloth and the under-side of the base is exposed.
6.
Insert and secure the four Housing Screws (using a grounded Phillips-head screwdriver) in their
respective locations, as shown in FIG. 16 on page 18.
7.
Replace any adhesive plastic "feet" that might have been removed during the removal process of the outer
housing.
These "feet" must be placed back onto their original locations so they can fit into their provided
openings on the Battery Base.
8.
Grasp both the LCD and housing and then rotate the entire unit back onto a flat surface.
9.
Insert all connectors and apply power.
Installation and Upgrade of the Internal NXD Components
Upgrading the cards within the WallMount panel involves removing the rear plastic outer housing (back box),
removing the existing card, replacing it with the 802.11g upgrade, and then placing the back box back onto the
NXD panel, as described in the following sections.
These panels do not come factory installed with the NXA-WC802.11GCF wireless interface card. This card
must be ordered separately from AMX as part of the 802.11g upgrade kit (
FG2255-07
).
Step 1: Remove the existing NXD Outer Housing
1.
Carefully detach all connectors from the side of the touch panel and remove the Faceplate from the front
of the panel.
2.
Place the LCD facedown on a soft cloth to expose the under-side of the unit (FIG. 22). This step helps
prevent scratching of the LCD
.
3.
Firmly press down on both connector overlay release latches (located in front of the connectors).
Pressing
down releases the connector overlay from atop the connectors.
4.
Gently slide the connector overlay away from the back box housing.
5.
Unscrew the outer housing (back box) by using a grounded Phillips-head screwdriver to remove the two
sets of pan-head Housing Screws, located on both sides of the housing (FIG. 22).
FIG. 22
Location of the attachment screws and connector overlay release latches on an NXD back box
Unscrew these
four pan-head
Two (2) connector
housing screws
to remove the
back box
overlay release latches
(2 per side)
The overlay connector must first be released before the rear back box can be
removed from the NXD-CV7 panel.
Summary of Contents for Modero CV7
