AMX Modero CV7, Operation/Reference Manual

Page: 38 / 220

CV7 Touch Panel Accessories
26 7" Modero Touch Panels
3.
Carefully insert the NXT-BP into the base until the battery securely fits onto the Battery Connector Port.
Installing the NXA-BASE/1 below an NXT-CV7 Panel
1.
Power Off the panel before attempting to attach the NXA-BASE/1.
2.
Place the battery base (with battery) onto a flat/level surface.
3.
Turn the battery locking slider (FIG. 28) to one side until the locking mechanism is horizontal to the base
(going left to right) and the rear battery latch is pointing directly outward (away from the LCD).
4.
Carefully angle the NXT-CV7 panel over the front alignment pegs (FIG. 29). The pegs assist in both
aligning and securing the panel to the base (the locking mechanism secures the base to panel when done).
5.
Insert the alignment pegs into their corresponding holes below the front of the panel.
6.
Verify the alignment of the Panel Interface connectors between the panel (female connector) and base
(male connector) (FIG. 29).
7.
Align the rear pegs and gently push the rear of the panel downwards until it is mounted atop the battery
base.
FIG. 27 Battery installation
FIG. 28 NXA-BASE/1 showing Panel Interface and connector locations
NXT-BP Battery
Battery
Connector
Battery
Connector
Port
FRONT
Panel Interface
connector (male)
Securing
pegs (2)
Front
Back
Battery
locking
mechanism
Battery
locking slider
Insert holes for
NXT-CV7 feet
Alignment
pegs (2)
(Battery not shown
for illustration purposes)