![background image](http://html1.mh-extra.com/html/amx/modero-cv7/modero-cv7_operation-reference-manual_2939251137.webp)
Firmware Pages and Descriptions
125
7" Modero Touch Panels
TTLS
(EAP Tunneled Transport Layer Security) was an authentication method, like PEAP, that does not
use a client certificate to authenticate the panel. This method is more secure than PEAP in that it does not
broadcast the identity of the user. The setup, although similar to PEAP, differs in the following areas:
An anonymous identity MUST be specified until the secure tunnel between the panel and the
Radius server is setup to transfer the real identity of the user.
There is no end-user ability to select from the different types of PEAP.
Additional Inner Authentication choices are available to the end-user.
An EAP-TTLS security method is designed for wireless environments where its necessary to first have
the Radius server directly validate the identity of the client (panel) before allowing it access to the
network. This validation is done by tunneling a connection through the WAP and directly between the
panel and the Radius server. By initially keeping the network out of the picture, there is far more security
validation going on behind the scenes before any possible access to the network is granted to the client.
Once the client is identified and then validated, the Radius server disconnects the tunnel and allows the
panel to access the network directly via the target WAP. Refer to the
EAP Authentication
section on
page 193 for further details on these security options. Refer to the
Using the Site Survey tool
section on
page 59 for more information on using this feature. Pressing the
EAP-TTLS
button opens the EAP-
TTLS Settings dialog (FIG. 109).
FIG. 109
Wireless Settings page - EAP-TTLS security method
Wireless Security - EAP-TTLS Settings
SSID (Service Set Identifier):
The SSID is the unique name used on the WAP and then assigned to all
panels in a wireless network that are communicating to the same target WAP.
• This is required by the WAP before the panel is permitted to join the
wireless network.
• It is case sensitive and must not exceed 32 characters, which may be any
keyboard character. Make sure this setting is the same for all points in your
wireless network.
• This unique string identifies the network and is the same string for all users
on the same network.
• Use the on-screen keyboard’s
Clear
button to completely erase any
previously stored SSID information.
• Note: In all cases, the SSID of the WAP must be entered. If it is left blank,
the panel will try to connect to the first access point which can be found that
supports EAP. In this situation however, a successful connection is not
guaranteed because the identified WAP may be connected to a RADIUS
server which does not support the specified EAP type and/or may not have
the proper user identities configured.
Required Information:
- SSID (Network Name used by the Target WAP)
- Identity (similar to the Username used for network access)
- Password (similar to the Password used for network access)
- Inner Authentication Type (supported by Devicescape)
Summary of Contents for Modero CV7
