5. Optional – Enter a description.
6. Click OK.
The Modify Preset dialog box opens.
7. For the first switch, click the source channel (input) and one or more
destination channels (outputs). Select multiple destination channels by
holding down the Control key while selecting the channels.
8. Click the Assign Switch button.
The input appears in the Assignment column of the Destination Channels
list; the switch will execute when the local preset is executed.
9. Disconnect inputs* or outputs as part of the local preset by selecting either
the source or destination channel and clicking the Disconnect button.
The input or output appears in its corresponding Disconnected Channels list;
the input or output will be disconnected when the local preset is executed.
10. Repeat Steps 7, 8, and 9 for all switches and / or disconnects to be included
in the preset.
Note:
For information on the other buttons and preset modifications, press F1
while the Manage Local Presets dialog box is open.
11. After all switches for the preset have been assigned, click OK and then close
the Manage Local Presets dialog box.
Define additional local presets by repeating the steps. When all local presets have
been defined, load the configuration file onto the system (see page 8-9). If local
presets are the only modifications that have been made to the Configuration file,
use the “Configure All Local Presets” option.
* Disconnecting an input will disconnect
all
outputs it is connected to.
Caution:
The system must
not
be actively switching when loading this
information onto the system.
8-8
Epica-128 & Epica-256 Installation & Setup
Managing Configuration Files
The Assignment column
shows three switches that
will be executed as Preset 1:
Input 2 to Output 5
Input 3 to Output 6
Input 7 to Output 8
The Disconnected Channels box
shows that Output 1 will be
disconnected as part of Preset 1.
Configuration
F
iles
