Ammann ASC 200 Series, Operating Manual

Page: 90 / 198

90 ASC110/ASC130/ASC150/ASC200/ASC250
2.7. Controlling and operation of the machine
Selecting driving direction and speed
•
Move the travel control 1 from neutral to the required
direction - little movement = low speed and vice versa.
Upon moving the travel control 1, the neutral 24 signal
lamp will go off.
Reversing - move the control 1 to the opposite direction
via neutral.
Note:
By means of the selector 8, it is possible to select the
operating speed of the engine; from the maximum to the
minimum operating speed according to the machine
load. The maximum parameters of the machine are
achieved at the maximum engine speed.
! NOTE !
Selector 2 - transport gear - can be
activated when driving on finished sur-
face.
It is possible to activate selector 2 while
the machine is under load; rabbit symbol
will light up.
Should towing power be insufficient,
turn the transport gear selector off 2.
Do not drive across (traverse)
slopes with high inclination!
Drive directly up the slope!
Prior to driving down a steep
slope, engage working gear
by deactivating selector 2!
Deactivate selector 2 while
the machine is stopped or
moving in a low speed! Do
not turn selector off at higher
speeds - this will cause rapid
deceleration and impact in
the hydraulic system.
Do not use engine speed
selector 8 to control the
machine speed.
If you have to stop the ma-
chine in a slope, first move
travel control 1 to neutral and
then press parking brake
button 4.