Ammann ASC 200 Series, Operating Manual

Page: 88 / 198

88 ASC110/ASC130/ASC150/ASC200/ASC250
2.7. Controlling and operation of the machine
•
After starting up, disconnect starting cables in reverse
order.
•
If using a starting power unit without connected batte-
ries, do not disconnect the power unit before a battery
will be connected in the machine.
! NOTE !
Starting voltage of the external starting
source must be 24 V.
Keep the specified order of operations
under all conditions!
1. Connect one terminal of the (+) cable pole to the (+)
pole of the flat battery.
2. Connect the other terminal of the (+) cable pole to
the (+) pole of the battery in the supporting machi-
ne.
3. Connect one terminal of the (-) cable pole to the
(-) pole of the battery in the supporting machine.
4. Connect the other terminal of the (-) cable pole to
the part of the started machine that is securely
connected to the engine (or connect the terminal to
the proper engine block).
Do not connect the (-) pole
cable to the
(-) pole of the flat battery in
the started machine! When
starting, extensive sparkling
may occur that might ignite
fumes generated by the
battery.
Prevent bare parts of starting cable clips
from mutual contact!
The starting cable connected to the (+)
pole of the battery must not come into
contact with electrically conducting parts
of the machine - risk of short circuit.
Do not lean over batteries - beware of
electrolyte burns!
Keep away sources of fire (open flames,
lit cigarettes etc.)
Do not test whether wires are live by
touching the frame of the machine!