Ammann APH 110-95, Operating Instructions Manual

Page: 54 / 166

3.5 En gine op er a tion
3.5.1 Dis play el e ments
The start ing con sole is equipped with sev eral warn ing lights. If
one of the warn ing lights goes on while the en gine is run ning, turn
the en gine off im me di ately and do not start it again un til the mal -
func tion has been rem e died.
• The tem per a ture warn ing light (1) mon i tors the en gine tem -
per a ture. It goes on when the en gine tem per a ture is high.
• The oil pres sure warn ing light (2) mon i tors the en gine oil pres -
sure. It lights when the en gine is off and the ig ni tion is on («
I »
po si tion) and must go out when the en gine is run ning.
• The glow mon i tor (3) lights dur ing the pre heat ing pro cess. As
soon as the light goes out, the pre heat ing pro cess is over and
the en gine can be started.
• The charge in di ca tor light (4) mon i tors gen er a tor func tion. It
lights when the en gine is off and the ig ni tion is on («
I » po si tion)
and must go out when the en gine is run ning.
• The en gine hour in di ca tor (5) can be used to call up var i ous in -
for ma tion:
• The bat tery ca pac ity through an LED di a gram dis play:
Right = bat tery ca pac ity full
Left = Bat tery empty
• En gine oil and air fil ter re place ment in ter vals are shown:
1. Serv.-
alarm 2. Serv.-
alarm 3. Serv.-
alarm 4. Serv.-
alarm
Dis play CHG
OIL CHG
OIL Serv
Air Fil ter CHG
Air Fil ter
In ter val 20 hours 200 hours 50 hours 250 hours
Count
down
—
15 hours
be fore
—
25 hours
be fore
Blink ing time 2 hours
• Op er at ing hours in whole hours.
3.5.2 Start ing the en gine
• Set the RPM le ver (1) about 1/3 of the way to « MAX ».
• Press the emer gency OFF switch (2).
• Turn the ig ni tion key (3) to « I » and
• wait for warn ing lights (2) and (4) to go on.
• When the en gine is cold, turn the ig ni tion key to « II » and hold
the key un til the pre heat ing dis play goes out.
• Turn the ig ni tion key to « III ».
3. Op er a tion
51