38
Amico Clinical Solutions Corp.
Terminal Block Usage
Terminal blocks are used to connect two wires together.
To insert a wire into the terminal block, observe the following instructions:
1. Insert a flat screw driver into the inner slot.
2. Push the back of the screw driver inwards.
3. Insert wire on the same side.
4. Remove screw driver.
5. Pull on the wire slightly to ensure that the wire is properly clamped.
Jumpers make the connection between two terminal blocks shown in the pic above.
Installation: Wiring Diagrams
Wire Here
Wire Here
Screw Driver Here
Screw Driver Here
Jumpers
