AMF REECE S100, Parts And Service Manual, Page: 50 / 93

S100
1-45
Revised 10/2005
e-mail: service@amfreece.cz ; parts@amfreece.cz ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
D - MACHINE ADJUSTMENT
1 9 . A D J U S T M E N T O F T H E L O O P E R S M O V E M E N T
Turn the left handle of the machine until the drive shaft is released. Turn the right hand wheel until the needle
bar is in the lower position of the center puncture.
Lift the machine head and after loosing of the screws
of the clutch is possible to turn by the sewing cam
until the timing gauge lines are aligned, which determines the correct position of the loopers adjustment.
C A U T I O N !
If there is no gauge line on the block, adjust the cam by the timing gauge line to the center
of the block.
Tighten the screws .
During the machine control is possible to check this adjustment when the threads are threaded. The needle
bar is in the lowest position, center puncture, timing gauge lines should be aligned.
Block timing gauge line
Cam timing gauge line