S100
1-15
Revised 10/2005
e-mail: [email protected] ; [email protected] ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
C - OPERATOR INSTRUCTIONS
1 . P R E PA R I N G T O S E W
1.
Read through all safety instructions and ensure all
covers are installed.
2.
Only Cord Trim
- Check on the air pressure
regulator that pressure is in range 4.5 - 5 bars
(0.45 - 0.50 MPa), see note above the regulator.
3.
Give oil to the manual oiling points and check the
correct oil quantity in oil level indicator.
4.
Check the needle and gimp threads are correctly
threaded.
5.
Before the first sewing, insert piece of fabric
similar to sewing work under the clamp feet.
6.
Insert the input cable into socket and by switching
on of the operating switch (circuit breaker)
switch the motor on.
7.
Drive of the machine is activated by the table foot
pedal .
C A U T I O N !
To make sure the machine is sewing
correctly, it is recommended to sew a few buttonholes on a
scrap piece of material before sewing on a quality garment.
8.
Insert the material under the clamp feet.
9.
To lower the clamp feet , move the lever
forward.
10.
Press the starting lever , the clamp feet are
automatically lowered. After the buttonhole is sewn
and cut, the clamp feet are raised.
11.
If the emergency stop button
is pressed and held
during sewing, the clamp feet will not raise at the
end of the sewing cycle and it is possible to sew the
buttonhole again.
12.
If it is necessary to interrupt the sewing cycle press
the stop lever
. The machine will finish the cycle
without
sewing and the clamp foot will raise. (if the
stop lever is pressed and then emergency stop is
pressed
the machine will finish the cycle without
clamp raising.
It is not valid for S 100 - CRB - see
section G 7
.
13.
To stop the machine immediately in any place of
sewing cycle, press foot pedal (by heel down the
sewing cycle is stopped, by toe the sewing cycle is
started.
14.
To start the sewing cycle without sewing, lift the
lever and after the cycle is started, the machine
makes cycle without sewing.