S100
1-9
Revised 10/2005
e-mail: [email protected] ; [email protected] ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
B - MACHINE INSTALLATION
3 . M A C H I N E U N PA C K I N G A N D A S S E M B L I N G
1.
After unpacking it is necessary to put the table together according to the enclosed documentation.
Delivered table is standardly took apart. For connection of the table frame, use enclosed connecting
parts. For ensuring of the conductive connection among all metal parts of the table is necessary to put
fan washers under the one of the two neighboring screws.
WA R N I N G !
Integrity of the protective connection of the machine metal parts must be kept according
to the section DOCUMENTATION - Wiring diagrams.
C A U T I O N !
The wiring assembly can perform only the person, who has an appropriate electrical
qualification.
2.
After putting the table together and wiring the assembly - before motor cover mounting, install the
table to the given place. Its stability is ensured by the rear abutment, which is controlled by the
manual screw.
3.
Before next assemblies of the machine, it is necessary to control if the motor turns in right direction, it
is marked
S
on drawing. The plug of supply, which is used as a main switch, put into the socket.
When the operational switch (circuit breaker) is switched on, activate the motor to run by the
foot pedal. Check the right rotational direction of the pulley according to the arrow placed on the
motor. Incorrect rotational direction of the electric motor can cause machine damage.
LEFT VIEW
Rotational direction
Motor
Operator