S100
1-11
Revised 10/2005
e-mail: [email protected] ; [email protected] ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
B - MACHINE INSTALLATION
7 .
Fold the rear covers and tilt the head in the frame, make rear screws accessible during the assembly.
Since some deliveries can have the covers partly dismantled, fix them to their place by using drawings
in parts manual. All safety covers must be assembled according to the section: I N T R O D U C
T I O N - Position of labels and safety equipment.
8 .
Oil reservoir should be placed between installed tall rubber washers.
9 .
The installation of the right driving belt (longer) is done by loosening the screw of the right cover and
its removal.
1 0 . If the left drive belt is not put on the upper pulley of the head (tilting the rear cover to have the access
to this belt), after loosening the inner screw of the frame, it is necessary to make adequate space
between the gear of the hand drive and the gear of the rear shaft by tilting the frame.
11 . After belt installation, tighten the frame inner screw again so that both gears fit in, use the
hand wheel.
If the belts are correctly mounted, they will not touch the covers or bedplate.
C A U T I O N !
After installing the belts, install the motor cover. It is necessary to connect the cover,
machine head and motor by the protective circuit breaker.
1 2 . Before operating the machine, install the clip
and the screw
from the accessories on the rear
cover.
Folding
rear cover
Inner screw
of the frame
Rear shaft gear
Hand drive gear
Frame